Suzuki Liana RH413 Service Manual page 599

DTC Troubleshooting
Step
1 Was "A/T System Check" performed?
2 Check input shaft speed sensor circuit
1) Disconnect TCM connectors with ignition switch OFF.
2) Check for proper connection to input shaft speed sensor
at "G07-5" and "G07-17" terminals.
3) If OK, check resistance of sensor circuit.
Input shaft speed sensor
Between terminals "G07-5" and "G07-17": 560 – 680
Ω at 20 °C (68 °F)
Between terminal "G07-5" / "G07-17" and ground:
No continuity
Are check result satisfactory?
3 Inspect input shaft speed sensor
1) Inspect input shaft speed sensor referring to "Input Shaft
Speed Sensor Inspection".
Is result satisfactory?
4 Check visually input shaft speed sensor and direct
clutch drum for the following
• No damage
• No foreign material attached
• Correct installation
Are they in good condition?
Action
I2RH0B510020-01
Automatic Transmission/Transaxle:
Yes
Go to Step 2.
Go to Step 4.
"RED" or "GRN" circuit
open or short.
Intermittent trouble or
faulty TCM.
Check for intermittent
referring to "Intermittent
and Poor Connection
Inspection in Section
00".
If OK, substitute a
known-good TCM and
recheck.
5A-51
No
Go to "A/T System
Check".
Go to Step 3.
Replace input shaft
speed sensor.
Clean, repair or replace.