1J-8 Charging System:
Generator Components
1. Pulley nut
2. Pulley
3. Drive end frame
4. Stator
5. Stud bolt
Generator Inspection
Rotor
1) Using an ohmmeter, check for continuity between
slip rings of rotor. If there is no continuity, replace the
rotor.
Standard resistance between slip rings of rotor
2.7 – 3.1 Ω at 20 °C (68 °F)
6. Drive end bearing
11. Wave washer
7. Bearing retainer
12. Rear end frame
8. Rotor
13. Seal plate
9. End housing bearing
14. Rectifier
10. Bearing cover
15. Insulator
S3RH0A1A06007
IYSQ011A0042-01
16. Regulator
17. Brush
18. Brush holder
19. Brush holder cover
20. Rear end cover
2) Using an ohmmeter, check that there is no continuity
between slip ring and rotor. If there is continuity,
replace the rotor.
3) Check slip rings for roughness or scoring. If rough or
scored, replace the rotor.
Using a vernier caliper, measure the slip ring
diameter. If the diameter is less than minimum,
replace the rotor.
Slip ring diameter
Standard: 14.2 – 14.4 mm (0.560 – 0.566in.)
Limit: 12.8 mm (0.503 in.)
S3RH0A1A06006
I2RH0B1A0008-01
21. Terminal plate
: Tightening torque
IYSQ011A0043-01