Suzuki Liana RH413 Service Manual page 454

3D-2 Propeller Shafts:
Propeller Shaft Removal and Installation
Removal
1) Hoist vehicle.
2) Before removing propeller shaft, give match marks
(2) on joint flange and propeller shaft as shown.
3) Separate No.2 propeller shaft (3) from rear
differential flange.
4) Remove No.1 propeller shaft (1) from transfer output
flange.
5) Remove propeller shaft center support brackets (4)
S3RH0A3406001
from vehicle body.
CAUTION
!
• Bracket and No.1 & No.2 shaft are removed
in one without separation.
• Use care not to drop it.
Installation
Reverse removal procedure to install propeller shaft,
noting the following point.
• When installing propeller shaft, align the match marks
(2). Otherwise, vibration may occur during driving.
• Use the following specification to torque each bolt and
nut.
Tightening torque
Propeller shaft No.1 bolt (a): 23 N·m (2.3 kgf-m, 17.0
lb-ft)
Propeller shaft No.2 bolt (b): 23 N·m (2.3 kgf-m, 17.0
lb-ft)
Center coupling bolt (c): 23 N·m (2.3 kgf-m, 17.0 lb-
ft)
Center support nut (d): 50 N·m (5.0 kgf-m, 36.5 lb-ft)
I3RH0A340003-01
I3RH01342004-01
I3RH01342005-01