Suzuki Liana RH413 Service Manual page 703

81) Install new gaskets (2) and then install fluid cooler
pipes.
Tightening torque
Fluid cooler pipe union bolt (b): 22 N·m (2.2 kgf-
m, 16.0 lb-ft)
Fluid cooler pipe bracket bolt (c): 10 N·m (1.0
kgf-m, 7.5 lb-ft)
82) After applying A/T fluid to new O-ring, fit it to fluid
filler tube. Then install fluid filler tube to transaxle
case.
Tightening torque
Fluid filler tube bolt (d): 10 N·m (1.0 kgf-m, 7.5
lb-ft)
(d)
(c)
83) Install select cable bracket (1).
Tightening torque
Select cable bracket bolt (a): 23 N·m (2.3 kgf-m,
17.0 lb-ft)
(a)
(b)
2
1, (a)
I2RH0B510328-01
1
I2RH0B510329-01
Automatic Transmission/Transaxle:
84) Apply A/T fluid to O-rings of each sensor and install
input shaft speed sensor (1) and output shaft speed
sensor / VSS (2).
Tightening torque
Input shaft speed sensor bolt (a): 5.5 N·m (0.55
kgf-m, 4.0 lb-ft)
Output shaft speed sensor / VSS bolt (b): 13
N·m (1.3 kgf-m, 9.5 lb-ft)
85) Install select cable clamp (3).
Tightening torque
Select cable clamp bolt (c): 23 N·m (2.3 kgf-m,
17.0 lb-ft)
3
1
(a)
86) Install transmission range sensor to transaxle case,
tighten bolts (1) temporarily at this step.
1
87) Install lock washer (1) and tighten lock nut (2) to
specified torque.
Tightening torque
Transmission range sensor lock nut (a): 7 N·m (
0.7 kgf-m, 5.0 lb-ft)
5A-155
(c)
(b)
2
I2RH0B510330-01
I2RH0B510331-01
1
2, (a)
I2RH0B510332-01