Air Bag Diagnostic System Check - Suzuki Liana RH413 Service Manual

• Damaged connector body, exposing the terminals to
moisture and dirt, as well as not maintaining proper
terminal orientation with the component or mating
connector.
• Improperly formed or damaged terminals.
Check each connector terminal in problem circuits
carefully to ensure good contact tension by using the
corresponding mating terminal included in the
connector test adapter kit (special tool).
If contact tension is not enough, reform it to increase
contact tension or replace.
Special tool
(A): 09932-76010
• Poor terminal-to-wire connection.
Check each wire harness in problem circuits for poor
connection by shaking it by hand lightly. If any
abnormal condition is found, change the wire harness
assembly or component parts with new ones.
• Wire insulation which is rubbed through, causing an
intermittent short as the bare area touches other
wiring or parts of the vehicle.
• Wire broken inside the insulation. This condition could
cause a continuity check to show a good circuit, but if
only 1 or 2 strands of a multi-strand-type wire are
intact, resistance could be far too high.

Air Bag Diagnostic System Check

WARNING
!
To avoid deployment when troubleshooting
the air bag system, do not use electrical test
equipment such as a battery powered or AC
powered voltmeter, ohmmeter, etc., or any
type of electrical equipment other than that
specified in this manual. Do not use a non-
powered probe type tester.
Instructions in this manual must be followed
carefully, otherwise personal injury may
result.
CAUTION
!
The order in which diagnostic trouble codes
are diagnosed is very important. Failure to
diagnose the diagnostic trouble codes in the
order specified may result in extended
diagnostic time, incorrect diagnosis and
incorrect parts replacement.
I3RH0A820086-01
The diagnostic procedures used are designed to find
and repair air bag system malfunctions.
To get the best results, it is important to use the
diagnostic flow tables and follow the sequence in the
following.
1) Perform the "Air Bag Diagnostic System Check
Flow".
(The "Air Bag Diagnostic System Check Flow" must
be the starting point of any air bag system diagnosis.
The "Air Bag Diagnostic System Check Flow" checks
for proper "AIR BAG" warning lamp operation
through "AIR BAG" warning lamp and whether air
bag diagnostic trouble codes exist.)
2) Refer to the proper diagnostic table as directed by
IYSQ01010028-01 the "Air Bag Diagnostic System Check Flow".
(The "Air Bag Diagnostic System Check Flow" will
lead you to the correct table to diagnose any air bag
system malfunctions. Bypassing these procedures
may result in extended diagnostic time, incorrect
diagnosis and incorrect parts replacement.)
Air Bag System: 8B-12
IYSQ01820025-01
S3RH0A8204003