Suzuki Liana RH413 Service Manual page 700

5A-152 Automatic Transmission/Transaxle:
68) After applying A/T fluid to new O-ring, fit it to
transaxle case plug (1). Then install the transaxle
case plug to transaxle case (2).
Tightening torque
Transaxle case plug (a): 7.5 N·m (0.75 kgf-m, 5.5
lb-ft)
69) Install new O-rings to each accumulator piston and
apply A/T fluid to them.
Accumulator O-ring dimension
O-ring name
Large B1 accumulator O-ring (2)
Large C1 accumulator O-ring (2)
Large C2 accumulator O-ring (2)
– Above three O-rings are same.
Small B1 accumulator O-ring (4)
Small C1 accumulator O-ring (6)
Small C2 accumulator O-ring (6)
– Above two O-rings are same.
NOTE
Make sure that O-rings are not twisted or
caught when installing.
I2RH0B510316-01
I2RH0B510317-01
Inside Section
diameter diameter
29.4 mm 2.6 mm
(1.16 in.) (0.10 in.)
19.7 mm 2.6 mm
(0.78 in.) (0.10 in.)
21.8 mm 2.6 mm
(0.86 in.) (0.10 in.)
70) Install B1, C1, C2 accumulator pistons and springs.
Accumulator piston identification
Piston name
B1 accumulator piston (3)
C1 accumulator piston (5)
C2 accumulator piston (8)
Accumulator spring identification
Color of
Spring name identification
paint
B1
accumulator Pink
No.2 spring (1)
C1
accumulator Blue
No.2 spring (7)
C2
accumulator Light Green
No.2 spring (9)
Identification as
embossed letters on
piston
SB-1
SC-1
SC-2
Free Outside
length diameter
47.1 mm 16.0 mm
(1.854 in.) (0.630 in.)
28.1 mm 16.8 mm
(1.106 in.) (0.661 in.)
57.2 mm 17.5 mm
(2.252 in.) (0.689 in.)
I2RH0B510318-01