Suzuki Liana RH413 Service Manual page 18

00-11 Precautions:
Air Bag Warning
WARNING
!
For vehicles equipped with Supplemental
Restraint (Air Bag) System:
• Service on and around the air bag system
components or wiring must be performed
only by an authorized SUZUKI dealer. Refer
to "Air Bag System Components, Wiring
and Connectors Location in Section 8B" in
order to confirm whether you are
performing service on or near the air bag
system components or wiring. Please
observe all WARNINGS and "Precautions
on Service and Diagnosis of Air Bag
System in Section 8B" before performing
service on or around the air bag system
components or wiring. Failure to follow
WARNINGS could result in unintentional
activation of the system or could render
the system inoperative. Either of these two
conditions may result in severe injury.
• Technical service work must be started at
least 90 seconds after the ignition switch is
turned to the "LOCK" position and the
negative cable is disconnected from the
battery. Otherwise, the system may be
activated by reserve energy in the Sensing
and Diagnostic Module (SDM).
Air Bag System Service Warning
WARNING
!
• Service on or around the air bag system
components or wiring must be performed
only by an authorized SUZUKI dealer.
Please observe all WARNINGS in "Air Bag
System" and "Precautions on Service and
Diagnosis of Air Bag System in Section
8B" before performing service on or
around the air bag system components or
wiring. Failure to follow WARNINGS could
result in unintended activation of the
system or could render the system
inoperative. Either of these two conditions
may result in severe injury.
• The procedures in the air bag system
section must be followed in the order
listed to disable the air bag system
temporarily and prevent false DTCs from
setting. Failure to follow procedures could
result in possible air bag system
activation, personal injury or otherwise
unneeded air bag system repairs.
Fastener Caution
S3RH0A0000007
CAUTION
!
When fasteners are removed, always reinstall
them at the same location from which they
were removed. If a fastener needs to be
replaced, use the correct part number
fastener for that application. If the correct
part number fastener is not available, a
fastener of equal size and strength (or
stronger) may be used. Fasteners that are not
reused, and those requiring thread-locking
compound, will be called out. The correct
torque value must be used when installing
fasteners that require it. If the procedures are
not followed, parts or system damage could
result.
Suspension Caution
CAUTION
!
• All suspension fasteners are an important
attaching part in that it could affect the
performance of vital parts and systems,
and/or could result in major repair
expense. They must be replaced with one
of the same part number or with an
equivalent part if replacement becomes
necessary. Do not use a replacement part
of lesser quality or substitute design.
Torque values must be used as specified
during reassembly to assure proper
S3RH0A0000008
retention of this part.
• Never attempt to heat, quench or
straighten any suspension part. Replace it
with a new part or damage to the part may
result.
Wheels and Tires Note
NOTE
All wheel fasteners are important attaching
parts in that they could affect the
performance of vital parts and systems, and/
or could result in major repair expense. They
must be replaced with one of the same part
number or with an equivalent part if
replacement becomes necessary. Do not use
a replacement part of lesser quality or
substitute design. Torque values must be
used as specified during reassembly to
assure proper retention of all parts.
There is to be no welding as it may result in
extensive damage and weakening of the
metal.
S3RH0A0000009
S3RH0A0000010
S3RH0A0000011