Clutch Release System Inspection - Suzuki Liana RH413 Service Manual

5C-13 Clutch:
2) Install release shaft with return spring.
3) Apply grease to No.2 bush (1) inside and press-fit it
by using the same special tool as in removal.
"A": Grease 99000–25010
Special tool
(A): 09922–46010
4) Coat grease to release shaft oil seal (2) and then
install it till it is flush with case surface. Use special
tool for this installation and face seal lip downward
(inside).
"A": Grease 99000–25010
Special tool
(B): 09925–98221
5) Caulk seal at A by using caulking tool and hammer.
3. Release shaft
4. Caulking
6) Hook return spring.
7) Apply grease to release bearing inside diameter and
release shaft arm (2), then set release bearing (1).
"A": Grease 99000–25010
8) Apply small amount of grease to input shaft (3)
spline and front end as well.
"B": Grease 99000–25210
I2RH01530031-01
9) Set release arm to release shaft aligning their punch
marks (1), then tighten nut (2) and bolt.
Tightening torque
Release arm nut (a): 23 N·m (2.3 kgf-m, 17.0 lb-
ft)

Clutch Release System Inspection

1) Check clutch release bearing for smooth rotation.
2) Inspect smoothness of release bearing retaining
portion of transaxle case and correct or replace right
case as necessary.
I3RH0A530003-01
CAUTION
!
Do not wash release bearing. Washing may
cause grease leakage and consequential
bearing damage.
I3RH0A530004-01
I2RH01530034-01
S3RH0A5306019