Specifications; P/S System Specification And Service Data - Suzuki Liana RH413 Service Manual

6C-21 Power Assisted Steering System:
• Check clearance between rotor and vane.
Clearance between rotor and vane
Standard: 0.01 mm (0.0004 in.)
Limit: 0.06 mm (0.0023 in.)
1. Thickness gauge
Replace pump assembly if any abnormality is found.
Relief Valve (Flow Control Valve) and Its Spring
• Check fluid passage of relief valve and orifice of
connector for clogging by any obstruction.
• Check sliding surface of relief valve for wear and
damage.

P/S System Specification and Service Data

Item
Relieved pressure 8,200 – 8,900 kPa (82 – 89 kg/cm
Hydraulic pressure
Control Control device
Power steering pressure switch
Specified fluid
Fluid capacity of system
Steering Wheel Play
Steering force
• Check free length of relief valve spring (1).
Free length of relief valve spring
I2RH01630043-01
Standard: 22.0 mm (0.866 in.)
Limit: 19.0 mm (0.748 in.)
Replace pump assembly if any abnormality is found.

Specifications

Flow control valve
Relief valve
Switch turns on (closes) when the pressure is higher than 2,400 – 3,100
kPa (24 – 31 kg/cm 2 , 341 – 441 psi). ECM uses this signal for idle speed
control.
An equivalent of DEXRON
LH steering About 0.70 liters (1.5 / 1.2 US/Imp pt.)
RH steering About 0.63 liters (1.3 / 1.1 US/Imp pt.)
CAUTION
!
The value is rough amount of fluid in entire system. Fluid level
should be in between "LOWER" and "UPPER" level marks on
fluid reservoir, which means that appropriate amount of fluid is
in it. (For details, refer to "P/S Fluid Level Check".)
0 – 30 mm (0 – 1.18 in.)
Less than 40 N (4.0 kg, 8.8 lb)
Refer to "Steering Force Check".
Specification
or 1,166 – 1,265 psi)
2
® ®
-III, DEXRON -IIE or DEXRON
I2RH01630044-01
I2RH01630045-01
S3RH0A6307001
®
-II