Rear; General Description; Rear Drive Shaft Description; Repair Instructions - Suzuki Liana RH413 Service Manual

Rear

Rear Drive Shaft Description

A ball fixed type constant velocity joint is used on the wheel side of rear drive shaft and a double offset type constant
velocity joint (DOJ) on the differential side.

Rear Drive Shaft Components

1. Wheel side joint
: Apply light black grease included in spare part to joint.
2. Boot band
3. Boot

Rear Drive Shaft Removal and Installation

Removal
1) Remove caulking of drive shaft nut (2) and then
remove drive shaft nut and washer (1).
2) Remove tire and drain rear differential oil referring
to"Rear Differential Oil Change in Section 3B".
3) Hoist vehicle.
4) Remove parking brake wire mounting bolt (1), rear
control rod outer bolts (2) and rear trailing rod rear
bolt (3).
Installation
Install drive shaft assembly by reversing removal
procedure and noting the following points.
• Be sure to use new drive shaft nut (1).

General Description

Repair Instructions

4. Drive shaft
5. Differential side joint (DOJ)
: Apply light black grease included in spare part to joint.
6. Snap ring
S3RH0A3126002
5) Install used clamp (2) to differential side joint (1) and
pull out drive shaft from rear differential gear case by
using tire lever (3).
I3RH01312002-01
6) Remove drive shaft.
Drive Shaft / Axle: Rear 3A-12
S3RH0A3121001
S3RH0A3126001
I3RH01312001-01
7. Circlip
8. Snap ring
: Do not reuse.
I3RH01312003-01
I3RH01312004-01