P/S Pump Drive Belt Removal And Installation; P/S Pump Drive Belt Inspection; Tie-Rod End Boot On-Vehicle Inspection; Tie-Rod End Removal And Installation - Suzuki Liana RH413 Service Manual

6C-9 Power Assisted Steering System:

P/S Pump Drive Belt Removal and Installation

Removal
1) Disconnect negative cable at battery.
2) Remove engine undercover of right side, and then
loosen tension pulley bolt (1) and nut (2).
3) Remove power steering belt.
Installation
1) Install belt to power steering pump pulley (1),
crankshaft pulley (2), A/C pulley (if equipped) (3) and
tension pulley (4).
2) Adjust belt tension by referring to "P/S Pump Drive
Belt Tension Adjustment".

P/S Pump Drive Belt Inspection

S3RH0A6306018
Check power steering belt for wear and cracks, and
replace as required.

Tie-Rod End Boot On-Vehicle Inspection

Check boot for crack and damage. If any, replace it with
a new one.

Tie-Rod End Removal and Installation

Removal
I2RH0B630005-01
1) Hoist vehicle, and then remove wheel.
2) Remove split pin (1), and then tie-rod end castle nut
(2).
3) Using special tool, remove tie-rod end from knuckle.
Special tool
(A): 09913-65210
I2RH0B630006-01
S3RH0A6306019
S3RH0A6306007
I2RH01630013-01
S3RH0A6306009
I2RH01630015-01
I2RH01630016-01