Suzuki Liana RH413 Service Manual page 704

5A-156 Automatic Transmission/Transaxle:
88) Install manual select lever (1) temporarily at this
step.
89) After shifting manual select lever counterclockwise
fully, select "N" range position by bringing it back 2
notches clockwise.
90) Remove manual select lever (1) at this step.
91) Loosen sensor bolts and align needle direction
shaped on lock washer (2) with "N" reference line (3)
on transmission range sensor by moving sensor in
rotative direction.
92) Tighten sensor bolts to specified torque.
Tightening torque
Transmission range sensor bolt (b): 5.5 N·m (
0.55 kgf-m, 4.0 lb-ft)
3
1
93) Bend dents of lock washer (1) in order to prevent
displacement of lock washer.
2
4, (b)
4, (b)
I2RH0B510333-01
I2RH0B510334-01
94) Install manual select lever (1).
Tightening torque
Manual select lever nut (a): 13 N·m (1.3 kgf-m,
9.5 lb-ft)
1
95) Install engine mounting LH bracket (1).
Tightening torque
Engine mounting LH bracket bolt (a): 55 N·m (
5.5 kgf-m, 40.0 lb-ft)
96) Install torque converter (3) noting the following
points.
CAUTION
!
• Before installing converter, make sure that
its pump hub portion is free from nicks,
burrs or damage which may cause oil seal
to leak.
• Be very careful not to drop converter on oil
pump gear. Damage in gear, should it
occur, may cause a critical trouble.
(a)
I2RH0B510335-01
(a)
1
(a)
I2RH0B510336-01