Suzuki Liana RH413 Service Manual page 745

3) Drive in spring pin from right side till it is flush with
differential case surface (for 2WD).
[A]: Left side
[B]: Right side
4) Press-fit left bearing (1) by using special tool and
copper hammer.
Special tool
(A): 09951–76010
2. Differential case
5) Press-fit new sensor rotor (1), putting groove (2) side
upward and using special tools and copper hammer.
Special tool
(A): 09913–75510
(B): 09944–78210
6) Press-fit right bearing (1) by using special tools and
copper hammer.
Special tool
(A): 09924–74510
(B): 09951–16060
(C): 09913–85230
I3RH0A520083-01
7) Hold differential assembly with soft jawed vise (3),
install final gear (2) (and bevel gear for 4WD) and
then tighten final gear bolts (1) to which thread lock
cement has been applied.
Apply thread lock cement to bolt thread when
reusing bolts.
CAUTION
!
I2RH01520074-01
Use of any other bolts than specified ones is
prohibited.
Manual Transmission/Transaxle:
2. Differential case
3. Differential side left bearing
5B-36
I3RH0A520027-01
I3RH0A520028-01