Suzuki Liana RH413 Service Manual page 350

2B-8 Front Suspension:
Installation
Install strut assembly by reversing removal procedure, noting the following instructions.
• Insert bolts in such direction as shown in figure.
• Tighten all fasteners to specified torque.
Tightening torque
Strut bracket nut (For 8.8 strength bolt) (a): 105 N·m (10.5 kgf-m, 76.0 lb-ft)
Strut bracket nut (For 12.9 strength bolt) (e): 90 N·m (9.0 kgf-m, 65.0 lb-ft)
Strut support nut (b): 28 N·m (2.8 kgf-m, 20.5 lb-ft)
Brake hose mounting bolt (c): 25 N·m (2.5 kgf-m, 18.0 lb-ft)
Stabilizer joint nut (d): 50 N·m (5.0 kgf-m, 36.5 lb-ft)
NOTE
• Don't twist brake hose and ABS wheel speed sensor harness (if equipped) when installing it.
• Install ABS wheel speed sensor harness (if equipped) to strut bracket as shown in figure.
• Strut bracket nut (for 12.9 strength bolt) is pre-coated with friction stabilizer and provided with
marks indicating the strength class. Never reuse this nut to prevent it from loosening. Be sure to
replace nut with a new one whenever loosening once.
• Be sure to use a bolt and nut in the right combination which is specified.
• Tighten wheel nut to specified torque.
Tightening torque
Wheel nut: 85 N·m (8.5 kgf-m, 61.5 lb-ft)
• After installation, confirm front wheel alignment.
[A]: 8.8 strength bolt & nut
[B]: 12.9 strength bolt & nut
I3RH0A220012-01