Suzuki Liana RH413 Service Manual page 382

2C-18 Rear Suspension:
5) Release parking brake lever and remove brake drum
screw and brake drum. Refer to "Rear Brake Drum
Removal and Installation in Section 4C".
6) Pull wheel hub (1) off by using special tools.
Special tool
(A): 09943-17912
(B): 09942-15511
7) Remove hub bolts (1). Refer to "Front Wheel Hub
and Steering Knuckle Disassembly and Assembly in
Section 2B".
8) Remove wheel bearing inner race (1).
Special tool
(C) : 09913-61510
(D) : 09925-88210
Installation
1) Install hub bolts. Refer to "Front Wheel Hub and
Steering Knuckle Disassembly and Assembly in
Section 2B".
2) Install outside inner race (1) to wheel hub (2) using
special tool. Installing direction is as shown.
CAUTION
!
Be sure to use new wheel bearing set (outer
race, bearings and inner races) and wheel
bearing oil seal.
Special tool
(E): 09940-53111
I3RH01232010-01
3) Apply grease to outside bearing, outside inner race
and oil seal lip.
"A": Grease 99000–25010 (SUZUKI Super
I3RH01232011-01
Grease A)
4) Install wheel hub to knuckle by tightening drive shaft
nut. Do not tap wheel hub.
I3RH01232012-01
I3RH01232013-01
I3RH01232014-01
I3RH01232015-01