Suzuki Liana RH413 Service Manual page 8

00-1 Precautions:
Precautions
Precautions
Precautions for Vehicles Equipped with a
Supplemental Restraint (Air Bag) System
WARNING
!
• The configuration of air bag system parts
are as shown in the figure. When it is
necessary to service (remove, reinstall and
inspect) these parts, be sure to follow
procedures described in Air Bag System
section. Failure to follow proper
procedures could result in possible air bag
system activation, personal injury, damage
to parts or air bag system being unable to
activate when necessary.
• If the air bag system and another vehicle
system both need repair, SUZUKI
recommends that the air bag system be
repaired first, to help avoid unintended air
bag system activation.
• Do not modify the steering wheel,
dashboard, or any other air bag system
components. Modifications can adversely
affect air bag system performance and
lead to injury.
• If the vehicle will be exposed to
temperatures over 93 °C (200 °F) (for
example, during a paint baking process),
remove the air bag system components
beforehand to avoid component damage
or unintended air bag system activation.
5
6
1
8
1. Air bag wire harness (in floor harness)
2. Passenger air bag (inflator) module
3. SDM
4. Seat belt pretensioner
5. Contact coil
6. Driver air bag (inflator) module
7. Side air bag (inflator) module (if equipped)
8. Side sensor (if equipped)
S3RH0A0000001
2
7
3
4
7
8
4
I3RH0A000001-01
Precautions
Diagnosis
• When troubleshooting air bag system, be sure to
follow "Diagnosis". Bypassing these procedures may
result in extended diagnostic time, incorrect
diagnosis, and incorrect parts replacement.
• Never use electrical test equipment other than that
specified.
WARNING
!
Never attempt to measure the resistance of
the air bag (inflator) modules (driver,
passenger and side) and seat belt
pretensioners (driver and passenger). It is
very dangerous as the electric current from
the tester may deploy the air bag or activate
the pretensioner.
I3RH0A000002-01