Suzuki Liana RH413 Service Manual page 695

35) After applying A/T fluid to rear planetary sun gear
subassembly and one-way clutch No.1 assembly (1),
install them in transaxle case (2).
36) After applying A/T fluid to rear sun gear thrust
bearing race (1), install it to rear planetary sun gear
(2).
37) After applying A/T fluid to rear sun gear thrust
bearing (1), install it to forward clutch hub (2).
38) After applying A/T fluid to forward clutch hub (1),
install it in transaxle case (2).
Automatic Transmission/Transaxle:
39) After applying A/T fluid to intermediate shaft thrust
bearing rear race (3), thrust bearing (2) and front
race (1), install them to forward and reverse clutch
assembly (4).
Bearing race dimension
Outside
diameter
Thickness
I2RH0B510290-01
40) Apply A/T fluid to forward and reverse clutch
assembly (1).
Install forward and reverse clutch assembly while
rotating clockwise and counter clockwise frequently
to fit clutch discs to mating hubs.
NOTE
Before installation, align teeth of forward and
I2RH0B510291-01
reverse clutch discs to facilitate installation.
I2RH0B510292-01
41) Check for correct installation of forward and reverse
clutch assembly as follows.
Measure distance "a" by using micrometer caliper (1)
and straightedge (2). If out of specification, remove
forward and reverse clutch assembly, forward clutch
hub, rear planetary sun gear subassembly and one-
way clutch No.1 assembly, and reinstall them
properly.
Distance between forward and reverse clutch
assembly and mating surface of transaxle case
"a": Less than 29.4 mm (1.157 in.)
I2RH0B510293-01
Front race
30.6 mm (1.20 in.) 28.2 mm (1.11 in.)
2.0 mm (0.08 in.) 2.0 mm (0.08 in.)
5A-147
Rear race
I2RH0B510294-01
I2RH0B510295-01