Suzuki Liana RH413 Service Manual page 494

4C-2 Rear Brakes:
5) Remove back plate plug (1) attached to the back
side of brake back plate so as to increase clearance
between brake shoe and brake drum.
Insert a screwdriver into plug hole till its tip contacts
shoe hold down spring and push screwdriver in the
arrow direction.
With this push, hold down spring is pushed up and
releases parking shoe lever from hold down spring,
resulting in larger clearance.
6) Pull brake drum off by using 8 mm bolts (1) (2
pieces).
Installation
1) Before installing brake drum, to maximize brake
shoe-to-drum clearance, put screwdriver between
rod (1) and ratchet (2) and push down ratchet as
shown in figure.
NOTE
The figure show ratchet position where brake
shoe-to-drum clearance is maximum.
I3RH0A430001-01
2) Put brake shoe hold down spring (2) back to its
original position as shown. (Put shoe hold down
spring in place by moving shoe lever (3) so that shoe
I2RH01430005-01
lever comes to the side of shoe hold down spring.)
I2RH01430008-01
I2RH01430009-01
1. Rod
2. Ratchet
I2RH01430010-01
1. Brake shoe