Suspension Control Arm / Bushing Removal And Installation - Suzuki Liana RH413 Service Manual

2B-16 Front Suspension:
• By rotating wheel actually, check wheel bearing for
noise and smooth rotation.
If defective, replace bearing.
Suspension Control Arm / Bushing Removal
and Installation
Removal
1) Remove suspension control arm ball joint bolt (1)
and nut (2).
F: Forward
2) Remove suspension control arm bolts (1).
3) Remove suspension control arm (2).
1
F
F: Forward
I2RH01220011-01
S3RH0A2206013
I2RH01220046-01
2
I4RH01220013-01
Installation
1) Install suspension control arm as shown but tighten
suspension control arm bolts (1) only temporarily.
1
2) Install suspension control arm ball joint to steering
knuckle. Align ball stud groove with steering knuckle
bolt hole. Then install ball joint bolt (1) from the
direction as shown in figure. Tighten suspension arm
ball joint nut (2) to specified torque.
Tightening torque
Suspension arm ball joint nut (a): 60 N·m (6.0
kgf-m, 43.5 lb-ft)
F: Forward
3) Lower hoist and vehicle in non-loaded condition,
tighten control arm mounting bolts (1) to specified
torque.
Tightening torque
Control arm mounting bolt (a): 90 N·m (9.0 kgf-
m, 65.0 lb-ft)
1, (a)
4) Confirm front wheel alignment referring to "Front
Wheel Alignment Inspection and Adjustment".
1
I4RH01220014-01
I2RH01220054-01
I4RH01220015-01