Replacing An Acx4000 Fiber-Optic Cable - Juniper ACX4000 Hardware Manual

2. Take each transceiver to be installed out of its electrostatic bag, and identify the slot on the
component where it will be installed.
3. Verify that each transceiver is covered by a rubber safety cap. If it is not, cover the transceiver with a
safety cap.
4. Carefully align the transceiver with the slots in the component. The connectors should face the
component.
5. Slide the transceiver until the connector is seated in the component slot. If you are unable to fully
insert the transceiver, make sure the connector is facing the right way.
6. Close the ejector handle of the transceiver.
7. Remove the rubber safety cap from the transceiver and the end of the cable. Insert the cable into the
transceiver.
LASER WARNING: Do not look directly into a fiber-optic transceiver or into the ends of
fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected to a
transceiver emit laser light that can damage your eyes.
8. Verify that the status LEDs on the front panel indicate that the transceiver is functioning correctly.
SEE ALSO
ACX4000 Front Panel Overview | 42
ACX4000 Uplink Ports Overview | 44
ACX4000 LEDs Overview | 52
Maintaining the ACX4000 Uplink Ports | 121
Replacing an ACX4000 Transceiver | 126

Replacing an ACX4000 Fiber-Optic Cable

IN THIS SECTION
Disconnecting an ACX4000 Fiber-Optic Cable | 129
Connecting an ACX2000 Fiber-Optic Cable | 130
128