Advertisement
CHAPTER 8
Transceiver and Cable Specifications
Pluggable Transceivers Supported on MX150
Copyright © 2017, Juniper Networks, Inc.
Pluggable Transceivers Supported on MX150 on page 37
SFP+ Direct Attach Copper Cables for MX150 on page 62
Cable Specifications for Console and Management Connections for the
MX150 on page 65
Understanding MX150 Fiber-Optic Cable Signal Loss, Attenuation, and
Dispersion on page 66
Calculating the Fiber-Optic Cable Power Budget for an MX150 on page 67
Calculating the Fiber-Optic Cable Power Margin for an MX150 on page 68
Uplink ports on MX150 support SFP and SFP+ transceivers. This topic describes the
optical interfaces supported for those transceivers. It also lists the copper interface
supported for the SFP transceivers.
NOTE:
We recommend that you use only optical transceivers and optical
connectors purchased from Juniper Networks with your Juniper Networks
device.
CAUTION:
If you face a problem running a Juniper Networks device that uses
a third-party optic or cable, the Juniper Networks Technical Assistance Center
(JTAC) can help you diagnose the source of the problem. Your JTAC engineer
might recommend that you check the third-party optic or cable and potentially
replace it with an equivalent Juniper Networks optic or cable that is qualified
for the device.
The tables in this topic describe the optical interface support over single-mode fiber-optic
(SMF) and multimode fiber-optic (MMF) cables and over the copper interface for SFP
transceivers:
Table 21 on page
38—Optical interface support and copper interface support for Gigabit
Ethernet SFP transceivers.
37
Advertisement
Chapters
