Management Port Connector Pinout Information For An Ex2200 Switch; Table 12: Ex Series Switches Console Port Connector Pinout Information - Juniper EX2200 Series Hardware Manual

Complete Hardware Guide for EX2200 Ethernet Switches

Table 12: EX Series Switches Console Port Connector Pinout Information

Pin
1
2
3
4
5
6
7
8
Related
Documentation

Management Port Connector Pinout Information for an EX2200 Switch

24
NOTE: If your laptop or PC does not have a DB-9 male connector pin and you
want to connect your laptop or PC directly to an EX Series switch, use a
combination of the RJ-45 to DB-9 female adapter supplied with the switch
and a USB to DB-9 male adapter. You must provide the USB to DB-9 male
adapter.
Signal
RTS Output
DTR Output
TxD Output
Signal Ground
Signal Ground
RxD Input
CD Input
CTS Input
See EX2200 Switches Hardware Overview on page 3
See Rear Panel of an EX3200 Switch for port location.
See Rear Panel of an EX3300 Switch for port location.
See Rear Panel of an EX4200 Switch for port location.
See Front Panel of an EX4500 Switch for port location.
See Switch Fabric and Routing Engine (SRE) Module in an EX6200 Switch for port
location.
See Switch Fabric and Routing Engine (SRE) Module in an EX8208 Switch for port
location.
See Routing Engine (RE) Module in an EX8216 Switch for port location.
Connecting an EX Series Switch to a Management Console on page 115
Configuring the Console Port Type (CLI Procedure)
The management port on an EX2200 switch uses an RJ-45 connector to connect to a
management device for out-of-band management.
Description
Request to send
Data terminal ready
Transmit data
Signal ground
Signal ground
Receive data
Data carrier detect
Clear to send
for port location.
Copyright © 2011, Juniper Networks, Inc.