Cisco Sx350 Cli Manual page 1187

System Management Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Parameters
•
in hhh:mm | mmm—(Optional) Schedules a reload of the software to take
effect in the specified minutes or hours and minutes. The reload must take
place within approximately 24 days.
•
at hh:mm—(Optional) Schedules a reload of the software to take place at
the specified time (using a 24-hour clock). If you specify the month and day,
the reload is scheduled to take place at the specified time and date. If you
do not specify the month and day, the reload takes place at the specified
time on the current day (if the specified time is later than the current time) or
on the next day (if the specified time is earlier than the current time).
Specifying 00:00 schedules the reload for midnight. The reload must take
place within 24 days.
•
day—(Optional) Number of the day in the range from 1 to 31.
•
month—(Optional) Month of the year.
•
cancel—(Optional) Cancels a scheduled reload.
Default Usage
None
Command Mode
Privileged EXEC mode
User Guidelines
The at keyword can be used only if the system clock has been set on the device.
To schedule reloads across several devices to occur simultaneously, synchronize
the time on each device with SNTP.
When you specify the reload time using the at keyword, if you specify the month
and day, the reload takes place at the specified time and date. If you do not
specify the month and day, the reload takes place at the specified time on the
current day (if the specified time is later than the current time), or on the next day (if
the specified time is earlier than the current time). Specifying 00:00 schedules the
reload for midnight. The reload must take place within 24 days.
To display information about a scheduled reload, use the show reload command.
62
1186