Option Card Installation; Prior To Installing The Option - YASKAWA L1000A Quick Start Manual

7 Option Card Installation

7 Option Card Installation
This section provides instructions on installing the option cards listed in

◆ Prior to Installing the Option

Prior to installing the option, wire the drive, make the necessary connections to the drive terminals, and verify that the
drive functions normally. Refer to the
Table 45 below lists the number of option cards that can be connected to the drive and the drive connectors for connecting
those option cards.
Option Card
PG-B3, PG-X3
PG-F3 , PG-E3
<2>
DO-A3, AO-A3
SI-S3, DI-A3
<3>
<1> If two PG option cards are connected, use both CN5-B and CN5-C. If only one PG option card is connected to the drive, use the CN5-C
connector.
<2> These option cards are not available for the application with Motor 2 Selection.
<3> When DI-A3 is to be used as monitors, the card can be connected to any of CN5-A, CN5-B or CN5-C. The input status of DI-A3 can
then be viewed using U1-17.
Figure 83 shows an exploded view of the drive with the option and related components for reference.
Figure 76
A – Insertion point for CN5
B – Option card
C – Included screws
D – Front cover
E – Digital operator
F – Terminal cover
150
Table 45 for information on wiring and connecting the drive.
Table 45 Option Card Installation
Connector
CN5-C
CN5-C
CN5-A, B, C
CN5-A
L
K
J
I
H
G
Figure 83 Installing an Option Card
YASKAWA ELECTRIC TOEP C710616 38H YASKAWA AC Drive-L1000A Quick Start Guide
Table 45.
Number of Cards Possible
A
B
C
D
E
F
G – Removable tabs for wire routing
H – Ground wire
I – Drive grounding terminal (FE)
J – Connector CN5-A
K – Connector CN5-B
L – Connector CN5-C
2
<1>
1
1
1
YEA_common