Table of Contents
Advertisement
9.3.2 Module Upgrade
To perform an upgrade, perform the following steps:
1.
Choose System>Module Upgrade.
2.
In the Module Upgrade area, click Browse. In the displayed dialog box, select the target
software version file.
3.
Click Open. The dialog box choses. The save path and name of the target software version
file are displayed in the Update file field.
4.
Click Submit.
5.
The software upgrade starts. After the upgrade, the CPE automatically restarts and runs the
new software version. As shown in Figure 9-9.
During an upgrade, do not power off the CPE or disconnect it from the computer.
9.4 FTP auto upgrade
To perform a ftp auto upgrade successfully, make sure the CPE is connected to the Internet.
To perform a ftp auto upgrade, perform the following steps:
1.
Choose System>FTP auto upgrade.
2.
Enable FTP auto upgrade.
3.
If you want to check new firmware after connect to Internet, you need to enable the item of Check
new firmware after connect to Internet.
4.
Set a ftp address to the Upgrade folder box.
5.
Set Version file.
6.
Set User name and Password.
7.
Set the Interval of checking new firmware.
8.
Set Start time.
9.
Set Random time.
10. Click Submit. As shown in Figure 9-10.
Figure 9-9
Advertisement
Table of Contents
