Setting The Poe Card Power Usage Threshold - Avaya 8300 Configuration

Procedure steps
Enable the power administration on the PoE card by using the following command:
config poe card <slotlist> admin
Important:
PoE card power administration is enabled by default.
If you install 8348TX-PWR or 8348GTX-PWR modules into an 80xx chassis, PoE is
disabled.
Variable definitions
Use the data in the following table to help you with config poe card <slotlist> admin
command.
Variable
admin
<enable|disable>

Setting the PoE card power usage threshold

Set the card power usage threshold for the PoE card.
Procedure steps
Set the PoE card usage threshold by using the following command:
config poe card <slotlist> power-usage-threshold
Variable definitions
Use the data in the following table to help you with config poe card <slotlist> power-
usage-threshold command.
Variable
power-usage-threshold
<0-99>
Configuration — Power over Ethernet
Sets the main power administration.
Sets the card power administration. The enable setting enables
card power administration. The disable setting disables card
power administration.
The value to set for the power usage threshold. The value
can be from 0 to 99 and is in percentage. The default is
80%.
Setting the PoE card power usage threshold
Value
Value
May 2011 41