Setting Ip Parameters Using The Web-Based Management Interface - Avaya 4500 Series Installation Manual

Installing the Avaya Ethernet Routing Switch

Setting IP parameters using the Web-based Management Interface

To set IP parameters using the Web-based Management Interface, perform the following
procedure.
Prerequisites Ensure that the switch has an IP address.
1. Connect a computer to the switch through a data port using a standard RJ-45
2. Open a Web browser on the attached computer and enter the IP address of the
3. Choose Configuration > IP from the menu. The following figure appears.
4. Use the fields on the IP configuration screen to configure the IP parameters. All
52 Installation
network cable.
switch in the following format: http://<nnn.nnn.nnn.nnn>. The main screen of the
Web-based Management Interface appears.
fields are divided into three columns: Configurable, In Use, and Last BootP. Use
the Configurable column to configure a new value for the field. The In Use column
represents the current value used by the switch, and the Last BootP column
supplies a value assigned to the field by a BootP request. The following table lists
and describes the fields on the IP configuration screen.
Field
In-Band Stack IP
Address
In-Band Switch IP
Address
In-Band Subnet
Mask
Description
The IP address used by the switch when it is part of a stack.
The IP address used by the switch when it is a stand-
alone unit.
The subnet mask used by the switch.
November 2010