Chapter 7: PoE configuration using the
This chapter describes how to configure Power over Ethernet (PoE) by using the Avaya Command Line
Interface (ACLI).
If you install 8348TX-PWR or 8348GTX-PWR modules into an 86xx chassis, PoE is disabled and you
cannot enable it.
Caution:
Risk of equipment failure
When you install and run Power over Ethernet modules, the 8310 or 8306 chassis cannot contain
various power supply types: all power supplies on the chassis must be of the same type (either Ethernet
Routing Switch 8301 or 8302 AC power supplies). Otherwise, all PoE 8348TX-PWR or 8348GTX-PWR
modules lose PoE power when the chassis detects the mixed power supplies.
Navigation
•
Job aid: Roadmap of PoE ACLI commands
•
PoE card settings configuration
•
PoE port settings configuration
Job aid: Roadmap of PoE ACLI commands
The following table lists the commands and the parameters you use to perform the procedures
in this section.
Table 8: Job aid: Roadmap of PoE ACLI commands
Privilege Executive mode
show poe sys-status
show poe main-status slot
Configuration — Power over Ethernet
ACLI
on page 50
on page 54
Command
on page 49
Parameter
<slotlist>
May 2011
49