Managing Power Over Ethernet (PoE)
Variable
unit <1–8>
Setting a power usage threshold
Set a percentage usage threshold above which the system sends a trap for each PWR+switch.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. At the command prompt, enter the following command:
poe poe-power-usage-threshold [unit <1–8>] {<1–99>}
Variable definitions
The following table describes the parameters for the poe poe-power-usage-threshold
command.
Variable
<1–99>
unit <1–8>
Enabling or disabling PoE traps
Enable or disable the traps for the PoE functions on the PWR+switch.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. At the command prompt, enter the following command:
Getting Started with Avaya ERS 3500 Series
104
Value
Set PD detection mode of an unit in stack
Value
Specifies the percentage of total available power you
want the switch to use prior to sending a trap.
DEFAULT: 80%
Set power usage threshold of an unit in stack
Comments on this document? infodev@avaya.com
Important:
Ensure that the power detection method you
choose for the ERS 3500–PWR+ matches that
used by the IP devices you are powering.
July 2015