Checking Status Leds To Verify Switch Installation - Avaya 5900 Series Installing

Checking status LEDs to verify switch installation

Perform this procedure to verify the hardware installation and operation of the unit.
The eight status LEDs on the front of the unit indicate the installation and operational status of the
hardware.
Before you begin
Perform the following tasks before checking the status LEDs.
• Install the fan trays and power supplies.
• Install the switch in an equipment rack or on a shelf.
• Connect power to the switch.
Procedure
1. Locate the status LEDs on the front of the unit; see the following figure.
Figure 18: Status LEDs
2. View the status LED states to verify that the fan trays and power supplies are installed and
operating correctly. You can also verify the status and operating mode of the unit.
For status LED state descriptions, see the following table.
Table 11: Status LED descriptions
LED
Base
February 2016
State
Off
Amber (Solid)
Amber (Blinking)
Installing Avaya ERS 5900 Series
Comments on this document? infodev@avaya.com
Checking status LEDs to verify switch installation
Description
The unit is operating in stand-alone mode. If
in a Stack, the switch is not a Base unit or a
Temporary Base unit.
The unit is operating as the Temporary Base
unit.
The unit has a Base unit election problem.
Multiple units are configured with a Base unit
Table continues...
51