SECTION 303-01C: Engine — Cobra 4.6L (4V)
IN-VEHICLE REPAIR
Camshaft Roller Follower
Special Tool(s)
Compressor, Valve Spring
303-452 (T93P-6565-AR)
Removal and Installation
1. Remove the left and right valve cover (6582). For additional information, refer to
LH
and
Valve Cover RH
2. Position the piston of the cylinder being repaired at the bottom of the stroke and camshaft lobe
at base circle.
3. Using the special tool, compress the intake valve spring and remove the roller follower.
4. Using the special tool, compress the exhaust valve spring and remove the roller follower.
5. Repeat Steps 2, 3 and 4 to remove all the necessary roller followers. Inspect roller finger
followers and camshafts. For additional information, refer to
6. To install, reverse the removal procedure.
in this section.
2003 Mustang Workshop Manual
Valve Cover
Section 303-00
.