Sensor (Front Tamper Hp) And Sensor (Rear Tamper Hp) Removals - Lexmark X850e Service Manual

Sensor (front tamper HP) and sensor (rear tamper HP) removals

1.
Remove the finisher front door assembly. See
2.
Remove the rear upper cover. See
3.
Remove the rear lower cover. See
4.
Remove the upper media bin assembly. See
5.
Remove the upper media bin vertical cover. See
6.
Remove the stapler unit frame. See
7.
Remove the media eject clamp motor assembly. See
page 4-143.
8.
Remove the media eject unit assembly. See
9.
Remove the media eject motor assembly. See
10.
Remove the media compiler unit assembly. See
page 4-146.
11.
Disconnect the connector from the sensor (front tamper HP) (A) or the sensor (rear tamper HP) (B).
12.
Release the hooks securing the sensor (front tamper HP) (A) or the sensor (rear tamper HP) (B) from the
media compiler unit assembly (C).
13.
Remove the sensor(s).
Note: The sensors are identical.
"Rear upper cover removal" on page
"Rear lower cover removal" on page
"Stapler unit frame removal" on page
B
Connector
"Finisher front door assembly removal" on page
"Upper media bin assembly removal" on page
"Right eject cover removal" on page
"Media eject clamp motor assembly removal" on
"Media eject unit assembly removal" on page
"Media eject motor assembly removal" on page 4-155
"Media compiler unit assembly removal" on
C
C
A
7500-XXX
4-101.
4-100.
4-97.
4-98.
4-131.
4-136.
A
4-149
Repair information
4-104.