Figure 88: Jumper Settings Without Remote Panel; Figure 89: Jumper Settings With Remote Panel; Figure 90: Internal Controller Voltages; Figure 91: Battery Parameters - Gamatronic POWER+ User Manual

6. View the system jumper settings without remote panel:
[Main Menu > SYSTEM > ▼ ▼ ▼]
JMP:
=IN
12369
7. View the system jumper settings with remote panel:
[Main Menu > SYSTEM > ▼ ▼ ▼]
JMP:
=IN
12369
Note: In Figure 88 and Figure 89, "Silicon mode" indicates that the configuration jumper is installed, thus
allowing for modifications. "Hard Silicon" indicates that the factory defaults hard reset jumper is
installed. This is required only at the factory or whenever software reset fails. Refer to section
7.15.9.3 for a detailed description of jumpers.
8. View the internal controller voltages:
[Main Menu > SYSTEM > ▼ ▼ ▼ ▼]
5VDC : 5.19V
12VDC: 12.01V
5VP : GOOD
5V2 : GOOD
9. View battery parameters:
[Main Menu > SYSTEM > ▼ ▼ ▼ ▼ ▼]
BATTERY CHARGE LEVEL:
WHILE TOTAL CAPACITY:
REMAINING BACKUP:
BATTERY TEMPERATURE:
Note: The data displayed in Figure 91 depends on the options installed and configured. See Figure 157 on
page 90 and Figure 193 on page 101.
64
G E
AMATRONIC
JMP1, JMP2, JMP3, JMP6 and JMP9
1. NOT HARD SILICON
2. SILICON MODE
3. CAPACITY LOW

Figure 88: Jumper settings WITHOUT remote panel

JMP1, JMP2, JMP3, JMP6 and JMP9
1. NOT HARD SILICON
2. SILICON MODE
3. CAPACITY LOW

Figure 89: Jumper settings WITH remote panel

CONTROLLER INTERNAL
-12VDC: GOOD

Figure 90: Internal controller voltages

Figure 91: Battery parameters

I L .
LECTRONIC NDUSTRIES TD
6. NO RMT PAN.
9. AC: 230V
6. Remote pan.
9. AC: 230V
VOLTAGES
010Ah 050%
020Ah
0010 MINUTES
12°C
POWER +
UPS, ,
PARALLEL USER GUIDE
. 2.0
REL