Setting Power Factor Correction; Setting The Sc2012; Figure 246: Service Menu; Figure 247: Enabling/Disabling Power Factor Correction - Gamatronic POWER+ User Manual

7.12.5

Setting Power Factor Correction

1. Select Powr.Calib:
[Main Menu > SETUP > (password) > Ent > Service]
1> ------
2> UPSs
3> ------- 6> En/Dis shar 9> SC2012..
Select, then Enter
Enable or disable power factor correction by using the ▲▼arrow keys and Ent::
2.
[Main Menu > SETUP > (password) > Ent > Service > Configure > Powr.Calib]
-- Set power correction factor value
Current Value:
Value to modify:
------ Use Up/down, Enter Or Esc ------
7.12.6

Setting the SC2012

1. Select SC2012:
[Main Menu > SETUP > (password) > Ent > Service]
1> ------
2> UPSs
3> ------- 6> En/Dis shar 9> SC2012..
Select, then Enter
2. Select Restart controller:
[Main Menu > SETUP > (password) > Ent > Service > SC2012]
1> Restart controller 3> Network...
2> Factory settings
Your selection: 1
Enter if you are sure (else press Esc.!)
A confirmation screen appears briefly and the controller restarts.
118
G E
AMATRONIC
4> DryOut Test 7> --------
5> Configure

Figure 246: Service menu

01%
02%

Figure 247: Enabling/disabling power factor correction

4> DryOut Test 7> --------
5> Configure

Figure 248: Service menu

4> Reset MBX
5> --------------

Figure 249: SC2012 menu

I L .
LECTRONIC NDUSTRIES TD
8> Powr.Calib
8> Powr.Calib
POWER +
--
UPS,
PARALLEL USER GUIDE
, . 2.0
REL