The Main Menu And Its Options; Table 12: Main Menu Options - Gamatronic POWER+ User Manual

8.3

The Main Menu and its options

The Main Menu of Power+'s built-in remote management software consists of a column of option buttons on
the left side of the Main Screen (see Figure 289 on page 133).
Table 12 lists the options in the Main Menu column on the Main Screen, and describes each option briefly.
Each option is described in greater detail in the subsequent sections.
M D
ENU OPTION
Displays a condensed system status: Alarm status and basic readings.
Main
Shows real-time readings for each input and output phase: voltage, current, kVA, kW,
Analysis
and power factor.
Displays status of individual UPS modules, shows input and output ac voltages and
Modules
currents, dc voltage, and active alarms if any.
Displays status of Static Switch, including inverter output voltages and frequency,
STSW
bypass voltages and frequency, and active alarms if any.
Log Displays system log; data can be printed or exported to an Excel file.
From this screen, the following system commands can be executed: Move load to
bypass, move load to inverter, start battery test, abort battery test, LEDs test,
shutdown, startup, restart, simulate load on battery condition, simulate battery status
is low.
Control
Use of this option is disabled by factory default. To enable (or disable), from the
Power+ console main menu choose the following:
(7) Setup > (8) Service > (5) Config > (8) Rem Command
View received or sent SMS Messages in this screen from this screen (Wing module
SMS
must be present). Click Available SMS commands to send an SMS message.
Configuration Configure the settings of the remote management software.
The Main Menu options are described in more detail below.
134
G
AMATRONIC

Table 12: Main Menu options

ESCRIPTION
E I L
LECTRONIC NDUSTRIES TD
POWER +
.
UPS,
PARALLEL USER GUIDE
, . 2.0
REL