The Power + Built - In Web Interface; Preliminaries To Use Of The Web Interface; Figure 288: Power+ Controller Rear Panel - Gamatronic POWER+ User Manual

8. T P
HE OWER
The Power+ built-in Web interface enables you to monitor and control the Power+ from a distance, using a
PC over an Ethernet network. All that is required is an HTML browser such as Microsoft's Internet Explorer.
8.1

Preliminaries to use of the Web interface

To enable the Power+ Web interface:
1. Consult with your Network Administrator to obtain an IP address for your Power+, and the
appropriate mask and gateway address.
2. Configure the Power+ with the IP address. This is done from the Power+ main menu as follows:
a. Setup > (enter your password, then press Ent; default password is 8 left arrows) > Service
> SC2012 > Network.
b. From the Network menu, choose IP Address and enter the assigned IP address.
c. From the Network menu, choose Gateway and enter the assigned Gateway address.
d. From the Network menu, choose Mask and set the assigned subnet mask.
e. From the Network menu, choose Store to save the information just entered.
3. Connect the Power+ to the local Ethernet network using the Ethernet (RJ45) port on the rear panel
of the Power+ controller. This is the port labeled "TCP/IP Port" on the left side of the controller rear
panel in Figure 288 below.
4. On a computer terminal that has connectivity to the Power+ IP address, open a Web browser and
enter the Power+ IP address in the URL bar. For example, type //192.102.2.130 and press Enter.
You should see the Web interface main screen (see Figure 289 below).
132
G E
AMATRONIC LECTRONIC
+ -
BUILT IN WEB INTERFACE

Figure 288: Power+ controller rear panel

I L .
NDUSTRIES TD
POWER +
PARALLEL
UPS, , . 2.0
USER GUIDE REL