Replacing The Parallel Controller; Figure 287: Setting Parallel Operation - Gamatronic POWER+ User Manual

7.16

Replacing the parallel controller

In the event that you are operating two Power+ systems in parallel and, due to controller malfunction or for
some other reason it becomes necessary to replace the controller, the replacement controller must be
instructed to act as a parallel controller.
To do this, select Parallel as shown in Figure 287 below and described in section 7.12.3.7, Selecting
Standalone or Parallel Operation, page 116.
[Main Menu > SETUP > (password) > Ent > Service > Configure > Parallel/StandAlone]
---
SELECT - 1: Stand Alone
SELECT - 2: Parallel
The new controller is now ready to operate in parallel mode.
POWER +
UPS,
PARALLEL USER GUIDE
G E
AMATRONIC LECTRONIC
Parallel / Stand-Alone Setup

Figure 287: Setting parallel operation

, . 2.0
REL
I L .
NDUSTRIES TD
---
(selected)
131