Third General Screen; Fourth General Screen; Figure 285: General (Screen 3); Figure 286: General (Screen 4) - Gamatronic POWER+ User Manual

7.15.9.3

Third General Screen

From the screen shown in the previous section, press ► to view screen 3:
[3-second Esc > GENERAL > ► > ►]
BOARD JUMPERS SETTING:
1. Not HARD Silicon
2. Silicon Mode
3. CAPACITY
A description of the various system parameters shown in screen 3 are listed below:
a. Not HARD Silicon: Must be HARD only initially, during first activation of non-configured controller.
After production, it should be Not HARD Silicon.
b. Silicon Mode: Regular mode allowing setup change. The setups are saved in an EEPROM chip.
c. CAPACITY HI (LO): High/low battery capacity mode when battery capacity is more/less than 100
Ah to achieve optimal resolution of the displayed value of battery current.
d. No/Yes Rmt Pan: Outputs of system controller are not configured or configured for an optional
remote panel connection.
e. AC: 220 V: Nominal ac input voltage: 220 V for 2x32 batteries, 110 V for 2x16 batteries in series.
7.15.9.4

Fourth General Screen

From the screen shown in the previous section, press ► to view screen 4.
[3-second Esc > GENERAL > ► > ► > ►]
SYSTEM OPERATION: PARALLEL MODE
REMOTE COMMANDS:
BYPASS CONTROL:
LINE FREQ./RANGE: AutoHz / 2Hz
A description of the various system parameters shown in screen 4 are listed below.
a. SYSTEM OPERATION: Indicates either standalone or parallel mode.
b. REMOTE COMMANDS: These commands can be enable or disabled.
c. BYPASS CONTROL: This command can be enabled or disabled.
d. LINE FREQ./RANGE: The line frequency control and its variation range is indicated.
130
G E I
AMATRONIC LECTRONIC NDUSTRIES
HI

Figure 285: General (Screen 3)

DISABLE
DISABLE

Figure 286: General (Screen 4)

L .
TD
6. No Rmt Pan.
9. AC: 220V
POWER +
PARALLEL
UPS, , . 2.0
USER GUIDE REL