Ing Wireless Control Option ); Installing The Wing; Figure 306: A Wing Unit Connected To The Powerplus - Gamatronic POWER+ User Manual

10. W :
ING
The POWER + system includes an option for wireless control and management, using the Gamatronic
Wing.
The Wing allows real-time detection of power system faults and immediately notifies selected recipients
(control center, technician, etc.) detailing the faults.
The Wing consists of:
•
Wing board.
•
SIM board.
•
Antenna.
•
D9-D9 cable (for RS232 between the Power+ and the Wing).
•
Dc power cable (banana plugs on both ends).
10.1

Installing the Wing

Note: The instructions in this section are for a Wing unit that has been ordered specifically for use
with a Power+ system. If your Wing was ordered for use with another type of system, it does not
contain the appropriate software for use with a Power+ system and you should contact your
Gamatronic representative if you wish to convert it for Power+ use.
To install a Wing unit for use with a Power+ system:
1. Take the Wing and press the button on the left side of the SIM slot to unlock the SIM cardholder;
remove the SIM card holder from the Wing.
2. Place your SIM card (which you obtained from your cellular service provider) in the SIM cardholder
and slide the SIM cardholder gently and firmly back into the Wing.
3. Attach the supplied cellular antenna to the Wing.
4. Connect the Wing to the D9 socket labeled "Wing" on the left rear side of the controller using the
supplied D9-D9 cable.
150
G
AMATRONIC
WIRELESS CONTROL
A Wing unit connected to the PowerPlus
Figure 306:
E I L
LECTRONIC NDUSTRIES TD
(
OPTION
POWER +
.
)
UPS,
PARALLEL USER GUIDE
, . 2.0
REL