Check Total Ampere-Hours; Figure 45: Battery Status; Figure 46: Battery Capacity; Figure 47: Set Battery Capacity - Gamatronic POWER+ User Manual

4.10.2

Check Total Ampere-Hours

This procedure is designed to ensure that the total capacity of the batteries attached to Power+ matches the
definition of the total capacity in the system controller.
1. Check the total capacity of the installed batteries attached to Power+.
2. Verify that the same value is specified in the system controller. If not, modify the definition in the
system controller to match the capacity of the installed batteries.
To check the capacity defined in the system controller:
1. From the Main Menu select option 5, Battery.
[Main Menu > BATTERY]
Battery capacity:
Charge mode
Eq. running time:
Charge current
The battery status panel displays the battery capacity defined in the system controller.
To set the battery capacity in the system controller to a different value:
1. Note the current value of battery capacity:
[Main Menu > BATTERY > ▼> ▼> ▼> ▼> ▼]
1> Battery#1: 020 Ah Total Cap.: 0020 Ah
2. Adjust the battery capacity to correspond to that of the attached batteries, and press Ent:
[Main Menu > SETUP > (password) > Battery > Capacity 0020AH) > Set Capacity of Battery #1]
Battery #01
Capacity
3. Repeat step 1 above to verify the set battery capacity.
POWER +
UPS,
PARALLEL USER GUIDE
G E
AMATRONIC LECTRONIC
0020Ah
: Floating
--------
: 053.0A

Figure 45: Battery status

Figure 46: Battery capacity

Capacity setup
10 -990
:020 Ah

Figure 47: Set battery capacity

, . 2.0
REL
I L .
NDUSTRIES TD
43