7.15
System Controller Setup Verification
The screens described below are useful for verifying system operation after replacing a controller
module(s). Especially important are the screens shown under the General section, as shown in Figure 273.
This verification procedure is available for software versions beginning from 050106.
Press Esc key for
three seconds to
view this menu
7.15.1
Setup Verification Menu
All of the functions listed below are for monitoring purposes only, except for setting the menu language.
[3-second Esc]
1> UPSs Stat
2> UPSs On/Off
3> SoftWare Rev
4> Network...
POWER +
UPS,
PARALLEL
USER GUIDE
G
E
AMATRONIC
LECTRONIC
1) UPSs Stat
2) UPSs On/Off
3) SoftWare Rev
4) Network...
5) Dry In/Out
Stat
6) Alarms Status
7) Language
8) General
Figure 273: Setup verification screens
1
Figure 274: Setup verification menu
,
. 2.0
REL
I
L
.
NDUSTRIES
TD
View connection status of
each UPS
View on/off status of each
UPS
Displays the firmware and
communication revisions
View the IP, Gateway,
Mask, and Faults
Displays the status of the
dry input and output relays
Displays the status of the
alarms
Set the menu language to English,
Spanish, or Portuguese ▲▼ <Ent>
<Ent> First screen:
10 viewable system parameters
► Second screen:
7 more viewable system parameters
► Third screen:
5 more viewable system parameters
► Fourth screen:
4 more viewable system parameters
5> Dry In/Out Stat
6> Alarms Status
7> Language
8> General
125