Physically Connecting Stratagy To Your Telephone System - Toshiba Stratagy 4 Installation And Maintenance Manual

STRATAGY 4/6/24
INSTALLATION AND MAINTENANCE MANUAL SEPTEMBER 1994
- POWER
(ON/OFF)
- KEY
LOCK
COM2
(default
local access) -
LPTl ~
PARALLEL
PRINTER
PORT
not used
AUXILIARY
POWER
OUTLET
110122ov
POWER SWITCH
AIC POWER
CORD
CONNECTOR
not
used
COM1
(default
remote access)
not used
PORTS 516
PORTS l/2
PORTS 314 -
Figure 3-6
Stratagy 4 and 6 Front and Back Panels (Sample Stratagy 6 with 6 Voice Board and 2 COM Ports)
1
VOICE
BOARD
PORTS
6.2 SETTING UP THE STRATACY 24
I If using 220V AC, connect the PC power cable
To set up Stratagy 24, do the following. For a diagram of
to the rear of the PC and to the dedicated 220V
the front and back panels, see Figure 3-7.
AC outlet. (We recommend you use a surge
protector.)
1. Place the Stratagy system PC on a table or desk
in the site determined by the pre-installation
7. If installing a printer, connect the 25pin data cable
survey.
from the printer to the RS-232 printer pot-t (LPTI)
2. Place the keyboard in front of the PC desktop.
on the back of the Stratagy system. Tighten the
screws. The printer must have a parallel interface.
3. Connect the round keyboard connector to the
matching connector located in a round hole in the
rear panel.
7 PHYSICALLY CONNECTING
4. Place the monitor on top of the Stratagy system
PC.
STRATAGY TO YOUR
5. Connect the 15pin monitor data cable to the
TELEPHONE SYSTEM
video/printer adapter card's 15pin connector
located on the rear panel. Tighten the screws with
IMPORTANT NOTE:
a small flathead screwdriver.
Before connecting Stratagy to your telephone
6. Connect the PC power cable.
sysfem, configure the yoke mail sysfem
q If using 11 OV AC, connect the PC power cable
to the rear of the PC and to the dedicated 1lOV
AC outlet. (We recommend you use a surge
protector.)
settings for your telephone system
individually. Refer to your telephone system's
insfallation documentation.
3-8