Setting Up Stratagy System Hardware; Setting Up The Stratagy 4 And 6 - Toshiba Stratagy 4 Installation And Maintenance Manual

STRATAGY 4/6/24
INSTALLATION AND MAINTENANCE MANUAL
SEPTEMBER 1994
SHOWN:ADDRESS300
(SETTING FOR BOARD
Figure 3-3
The Stratagy Voice Board
1)
Voice board 1 is factory installed and normally shipped
with address 300 (setting for board 1). Additional boards
are packaged separately. Set the jumper pins for each
voice board as follows. Note the following:
0: both pins are not covered/connected by a black
jumper pin (open)
7: both pins are covered/connected by a black jumper
pin (closed)
Board 1
Address 300 1111111100
Board 2 Address 301
0111111100
Board 3
Address 302 1011111100
Board 4
Address 303 0011111100
Board 5
Address 304 1101111100
Board 6 Address 305 0101111100
5.2.2 INSTALLING THE VOICE BOARD
To install the voice board in the Stratagy system, do the
following. See Figures 3-4 and 3-5 for the voice board
slots in the Stratagy 4 and 6 and Stratagy 24,
respectively.
1. If installing voice boards in an existing system,
from the Stratagy Main Menu shut down Stratagy
(see Chapter 4, "Accessing Stratagy" for details).
2. Turn computer's power off.
3. Unplug the power cord.
4. Open the computer and locate the first available
full length slot.
5. Remove the back slot cover and install the voice
board while taking care to properly slide the end of
the voice board into the rear card guide. Repeat
this for each voice board you are installing.
6. Close the computer, plug in the power cord, and
turn on the power. Stratagy should automatically
recognize the additional ports.
IMPORTANT NOTE:
Use only Stratagy voice boards supplied by
Toshiba. Non-Stratagy voice boards will
cause your entire system to be non-
operational.
6 SETTING UP STRATAGY
SYSTEM HARDWARE
6.1 SETTING UP THE STRATACY 4 AND 6
To set up Stratagy 4 and 6, do the following. For a
diagram of the front and back panels, see Figure 3-6.
1. Place the PC tower in the site determined by the
pre-installation survey.
2. Make sure the selectable power switch is at 11 OV
or 22OV, depending upon available input power.
3. Connect the PC power cable.
n If using 11 OV AC, connect the PC power cable
to the rear of the PC and to the dedicated 11 OV
AC outlet. (We recommend you use a surge
protector.)
,
n If using 220V AC, connect the PC power cable
to the rear of the PC and to the dedicated 220V
AC outlet. (We recommend you use a surge
protector.)
3-5