Addressing And Installing; Stratagy; Voice Boards - Toshiba Stratagy 4 Installation And Maintenance Manual

STRATAGY 4/6/24
INSTALLATION AND MAINTENANCE MANUAL
SEPTEMBER 1994
'
Environmental
Conditions
Electrical
Requirements
(AC Input)
Operating Temperature 39.2"F to 104°F (4°C to 40°C)
Storage Temperature 104°F to 140°F (-40°C to 60°C)
Operating Humidity
20% to 80% (non-condensing)
Stratagy 4, 6 or 24 115 VAC, at 6 amps (50/60 Hz)
230 VAC at 3.5 amps (50/60 Hz)
Monitor
115 or 230 VAC at 0.5 amps (50/60 Hz)
(Provide host system with 15 A circuit breaker and dedicated circuit)
Heat Dissipation
Analog Interface
Stratagy 4, 6, or 24 Maximum 200 watts, 685 BTU per hour
Monitor Maximum 50 watts, 200 BTU per hour
Telco types Loop Start, OPX
Connection Single line, RJ-14C jacks
Impedance 600 ohm nominal
Frequency response 300 - 3200 Hz
Ring detect
40 - 130 Vrms, 15.3 - 68.0 Hz
Loop current range 20 - 120 mA polarity insensitive
Transfer signaling Hook-flash
Input level -3 dB maximum, 130 dB/minimum
Output level -3 dB maximum, 30 dB/minimum
DTMF receive 16 tones (0 - 9, *, #, A - D)
Minimum tone duration 45 ms
Minimum tone detect -29 dB/minimum
Twist range
+-IO dB
DTMF transmit 16 tones (0 - 9, *, #, A - D)
Minimum tone duration
50 ms
Transmit level -7 dBm nominal
Twist range 2-3dB
Progress Tones
Standard and proprietary, in 350 - 640 Hz frequency range
Frequency response 200 - 300 Hz +3 dB/minimum
Speech Parameters -13 dB/minimum average transmit level for a -32 dBm receive level
Voice Coding Scheme 64 Kbs u-Law PCM, 32 Kbs ADPCM compression
Table 3-3
Stratagy Hardware Environmental and Electrical Specification Summary
Each Stratagy voice processing system has a unique
activation key-number that matches the Stratagy
software to a Stratagy voice board. This number is
entered into the system during manufacturing.
The activation key-number is written on a piece of
paper shipped with the Stratagy system. Store the
number in a safe place.
The activation key-number
must be entered to allow the
Stratagy system to operate under the following
conditions:
n The Stratagy factory-installed voice board is removed.
H The Stratagy hard disk drive is replaced or upgraded.
n The Stratagy system software is re-installed or
upgraded.
n Fault isolating or troubleshooting a Stratagy system
under direction of Toshiba Technical Support.
In most cases, you must re-enter the original activation
key-number shipped with the system. In other cases,
you must obtain a new activation key-number
by
contacting Toshiba.
3-4
5.2 ADDRESSING AND INSTALLING
STRATAGY VOICE BOARDS
Stratagy systems may be expanded to their maximum
capacity by installing additional Stratagy 2- or 4-port
voice boards. Installing a voice board into a Stratagy
system PC involves addressing the board before
installing it.
5.2.1 ADDRESSING THE VOICE BOARD
In order for Stratagy to recognize each voice board in a
system, each voice board is assigned a unique address.
The address of the first voice board is 300; the second,
address 301; the third, address 302, etc.
To set a voice board's address, you need to arrange the
10 jumper pins on the voice board in the correct manner.
The jumper pins are located along the top middle-right of
the board as you are looking at the component side of
the board with the 4-wire jacks on the right. See Figure
3-3.