Telephone - Toshiba Stratagy 4 Installation And Maintenance Manual

STRATAGY 4/6/24
INSTALLATION AND MAINTENANCE MANUAL
SEPTEMBER 1994
8.2 DEFINING TELEPHONE SYSTEM TONE
PATTERNS
Use this option to define for Stratagy the actual
telephone system tone patterns it must recognize when
performing supervised call transfers.
To define the tone patterns the Stratagy system uses a
utility called GetTones. This program enables Stratagy to
"learn" the tone patterns that define ringing, busy, hang
up, and reorder.
NOTE:
The tone patterns for Toshiba telephone systems
are automatically defined during setup. Use
GetTones only when initially configuring non-
Toshiba telephone systems.
8.2.1 PREPARING TO USE CETTONES
Before running GetTones, be sure you have done the
following:
n Defined the Telephone System Dial Codes.
n Connected port 1 and port 2 to valid, working
extensions on the telephone system.
H Found out the extension number to which port 1 is
connected.
n Verified that the extension that port 1 is connected to
is not in any hunt group,
forwarding defined.
and does not have any call
n Verified that the extension that port 2 is connected to
has outside line access and can dial a test telephone
number that will be answered (calling Time or
Weather are good choices).
n Defined a non-Stratagy extension that has a
telephone connected and will not be answered.
8.2.2 USING CETTONES
IMPORTANT NOTE:
Before you run the GetTones, you must have
done the previous.
To access GetTones, enter Y to the prompt.
Before GetTones can "learn" the tone patterns, it must
have some parameters defined. See Figure 5-9 for the
GetTones Utility Screen. For a list of the parameters and
their definitions, see Table 5-3.
After you complete the last parameter, GetTones obtains
the ring, busy, reorder, and hang up patterns of the
telephone system.
NOTE:
If you encounter any problems with GetTones,
you may need to run manual utilities to obtain
the telephone system tone patterns. Please
contact Toshiba Technical Support for more
information.
8.2.3 EXITING THE TELEPHONE SYSTEM TONE
PATTERNS SCREEN
When you have finished defining the Telephone System
Tone Patterns, press Esc to return to the Other Switch
Integrations Menu.
GetTones, version 1.1
Are you sure you want to run this routine? [y/n1 y
Enter the outdial code:
Enter the reorder code:
Enter the station number of port 1:
Enter the RNA test station number:
TRIAL Number: 1
Getting RING pattern.
If there is no activity after 30 seconds, press the Spacebar.
Figure 5-9
GetTones Utility Screen
5-29