Toshiba Stratagy 4 Installation And Maintenance Manual page 232

STRATAGY
4/6/24
INSTALLATION AND MAINTENANCE MANUAL SEPTEMBER 1994
CHAPTER 2
UPGRADING THE SYSTEM
1 INTRODUCTION
This chapter discusses upgrading an existing Stratagy
system. It focuses on:
W Installing screen savers
n Installing voice boards
4 1nstallin.g fax/modems
n Upgrading the Stratagy 4 to a Stratagy 6
2 INSTALLING SCREEN SAVERS
Stratagy contains a screen saver program that
automatically blanks the Main Menu after a specified
number of minutes of inactivity (per the Stratagy System
Configuration option tmo-blank). See the Installation
section, Chapter 5, "Configuring and Backup Up
Stratagy."
Installing a different screen saver program is not
recommended; Stratagy may not work.
3 INSTALLING STRATAGY VOICE
BOARDS
Installing a voice board into a Stratagy system PC
involves addressing the board before installing it.
Before starting the installation process, shut down
Stratagy. From the Main Menu, enter:
Alt + S
Enter the password (the default is Stratagy, with the first
letter uppercase). The Stratagy Configuration Utility
displays.
For details about Stratagy voice boards, including
addressing and installation, see the Installation section,
Chapter 3, "Installing the Hardware."
4 INSTALLING FAX/MODEMS
Installing a fax/modem in the Stratagy 24 involves
selecting one that meets specific requirements, installing
the hardware, and configuring Stratagy using the
Stratagy Configuration Utility. In addition, you (or the
System Administrator) will need to customize Stratagy to
send and receive faxes.
4.1 FAX/MODEM REQUIREMENTS
The fax/modem used in Stratagy 24 must be external
and meet the following requirements:
H Class 2 compliant (class 2 is different from class 2.0)
n UART 16550
l
Internal fax/modems must have a UART 16550
serial interface.
l
External fax/modems must be connected to UART
16550 serial ports.
4.2 INSTALLING FAX/MODEM HARDWARE
Installing the fax/modem. To install the hardware, follow
the manufacturer's instructions.
Configuring the fax/modem. Configure the fax/modem
as one of the following:
COMl with IRQ4 and no other devices on COMI or
using I RQ4.
COM2 with IRQ3 and no other devices on CQM2 or
using IRQ3.
4.3 CONFIGURING STRATAGY FOR
FAX/MODEMS
Set the following configuration parameters. See the
Stratagy System Configuration options in the Installation
section, Chapter 5, "Configuring and Backing Up
Stratagy" for details.
ext#: extension number where the fax/modem is
connected on the telephone system
fax#: fax/modem's fax number
x: access to outside line (usually '9')
COMI Settings:
COM2 Settings:
baud1 19200 baud2 19200
databitsl 8 databits 8
parity1 none parity2 none
serial-port1 1 serial-port2 2
fax1 'exf#' fax2 'ext#'
fax-dl-init 'x, faxdl-init 'x,
fax-id 'fax&" fax-id 'fax#
Additionally, set the following options for the fax modem:
fax-flow-control
fdax-Stan-character.
4.4 CUSTOMIZING STRATACY TO SEND
AND RECEIVE FAXES
For information on using the Token Programming
Language to customize Stratagy to send and receive
faxes, refer to the Programming section.
2-l