Seat Options - Otto Bock B600 Instructions For Use Manual

The B600 power wheelchair has been designed as a modu-
lar system. Certain component groups can be exchanged
and other accessories can be added.
The enAble50 control unit facilitates the use of numerous
additional electrical functions as well as customised input
devices.
The complete range of options is listed on the order form
and in the wheelchair accessories catalogue.
7.1 Seat Options
WARNING
Risk of injury due to tipping during operation. Before
driving up slopes or over obstacles, a tilted seat must be
lowered to its basic position, the lift seat must be in its
lowest position, and the back must be in the upright posi-
tion. Slightly tilt the seat to the rear when driving down in-
clines or over obstacles and reduce the speed (max. 3
km/h).
WARNING
Risk of pinching or crushing fingers. Do not reach into
the danger zone between the frame and the seat when
B600
tilting the seat. There must not be any interfering objects
or obstacles in the tilting zone.
CAUTION
Risk of injury when tilting the back rest. Overloading the
actuators can result in spindle nut breakage and thus
cause the seat to drop or the back rest to fold back.
INFORMATION
It is easier to tilt the seat if the back rest is inclined to the
rear.
INFORMATION
The seat function actuators are not intended for continu-
ous use, but only for short-term limited operation. General
recommendation: At maximum load capacity, 10 seconds
of operation should be followed by 90 seconds of idle
time. The electric seat functions are considered independ-
ently of the driving function for this purpose.
INFORMATION
When getting into or out of the power wheelchair, bring
the seat to a level position.
02/2010
Accessories
Page 141