Malfunctions / Troubleshooting; Warning; Error - Otto Bock B600 Instructions For Use Manual

Malfunctions / Troubleshooting
These and other optional add-on components are included
on the order form and in the wheelchair accessories cata-
logue.
8 Malfunctions / Troubleshooting
INFORMATION
Should you encounter problems while troubleshooting or if
you do not manage to completely eliminate a problem by
following the measures described here, please contact
your specialist dealer.
Malfunctions are indicated on the control panel LCD moni-
tor. Table 7 describes the individual error codes with the
corresponding problem sources as well as the possible
causes and resolutions.
If malfunctions cannot be fully corrected using the proce-
dures described here, an authorized dealer has the ability to
read the exact error code with a hand-held programming
device and to carry out a targeted system analysis.
All problems that have ever occurred are recorded and can
be retrieved, e.g. in case of a general overhaul of the power
wheelchair. For example, the saved data can be used to
determine future service and maintenance intervals.
Page 160

8.1 Warning

A warning indicates a status or malfunction of one or several
components of the power wheelchair. The function of com-
ponents that have no errors is not restricted. For example, if
the connection between the controller and seat motor mal-
functions, this error will only be indicated if the user attempts
to activate the motor. However, the driving function is still
available.

8.2 Error

CAUTION
Risk of injury due to stopping the wheelchair abruptly.
In the event of communication problems in the bus system
of the control unit, the system triggers an emergency stop
to prevent any uncontrolled functions. Depending on the
source of the malfunction, it is possible to drive the wheel-
chair out of a danger zone such as road traffic after
switching the control unit on again.
If the driving function is still not available after switching
the control unit on again, the brake must be deactivated
(see Section 6.4) to switch over to pushing mode. After
the power wheelchair has triggered an emergency stop,
contact a specialist dealer as soon as possible!
02/2010 B600