Safety Requirements For Care, Maintenance, And Disposal - Otto Bock B600 Instructions For Use Manual

Safety
INFORMATION
Road traffic regulations must be observed when driving on
the road.
INFORMATION
If the driving mode is changed while driving, the power
wheelchair will accelerate or decelerate.
INFORMATION
The control unit of the power wheelchair is protected ac-
cording to protection class IP 54 and the push button
module according to protection class IP 64. Accordingly
both can be used in bad weather (e. g. rain). The control
unit / push button module is approved for indoor and out-
door operation and meets the requirements regarding cli-
mate and splashed water.
INFORMATION
The controls of the power wheelchair must be reactivated
after an emergency stop. In the event of communication
problems in the bus system of the controls, the system
triggers an emergency stop and thus prevents any uncon-
trolled functions. If the driving function is still not available
Page 106
after reactivating the controls, the brake must be released
to switch over to pushing mode. In this case, contact a
specialist dealer as soon as possible.
INFORMATION
If the controls do not emit an error signal as soon as the
brake lever is activated, this indicates a malfunction. The
settings must be checked by a specialist dealer.
INFORMATION
Manoeuvring is only allowed at reduced speeds.
2.6 Safety Requirements for Care, Maintenance,
and Disposal
CAUTION
Risk of accidents and injury due to improper mainte-
nance, repairs, or adjustments. Maintenance work on
the power wheelchair may only be completed by person-
nel authorised and trained by Otto Bock. This also applies
to all repairs and settings on the brake. Incorrect settings
can lead to a loss of braking power.
02/2010 B600