Chapter 4 - Oce Arizona 440 GT User Manual

User Manual: Arizona (AZ) 440 GT, AZ 440 XT, AZ 460 GT, AZ 460 XT, AZ 480 GT, AZ 480 XT - Rev. B, 4/2013
Offsets
Print Pa‐
rameters
Print Modes Explained
• Express mode provides fast printing but image quality depends on all
nozzles jetting ink. It is best with images that do not have large areas of
solid color or high saturation.
• Production mode (Arizona 440 & 460) allows a wide variety of printing
output. As with high-speed modes on any inkjet printer, there is
insufficient nozzle redundancy to produce flawless images all the time
on all media. As a result, it may be necessary to print some output in
Quality Mode.
• Production-Smooth mode (Arizona 480) can be used to produce the
majority of printing output. As with high-speed modes on any inkjet
printer, there is insufficient nozzle redundancy to produce flawless
images all the time on all media. As a result, it may be necessary to
print some output in Quality Mode.
A job's vertical and horizontal offset parameters can be
changed with the mouse wheel when the mouse cursor is
positioned over the field. Rotate the mouse wheel up or
down increments or decrements offset at the rate of one
unit per notch. Hold the right mouse button and rotate the
wheel increments or decrements at the rate of 10 units per
notch. An alternate method to change parameter values is
to click on the field and this brings up an onscreen key-
board so you can click on the numbers required. You can
also use Preview to drag an image to the desired position.
Displays information about the print job that is currently se-
lected:
• Print Mode - Print modes are selected in Production-
House or THRIVE: Express, Production, Production-
Squared, Production-Smooth, Quality, Quality-Density,
Quality-Layered, Fine Art, or High Definition mode. See
"Print Modes Explained" below for details of each mode.
• Direction - Bidirectional and Forward or Reverse unidir-
ectional printing.
• Overprints - If the Overprint count is set to greater than 0
(zero), the printer will re-print the image again on the
same piece of media.
• Copies - use the mouse to increase or decrease.
• Type - Print Method - Flatbed or Roll.
• Media - Media that was selected in ProductionHouse.
• Notes - Appears only if a note was specified for the job.
Notes are entered in the ONYX software.
Chapter 4 - How to Navigate the User Interface
Print Job Control Module
55